PRODUCT IDENTIFICATION
| PRODUCT NAME |
EFFECTIVE DATE |
Applies to all Wynn's products with the following prefix: |
Wynn's Professional Products
Oil System Cleaner & Conditioner |
08-30-05 |
61603, 61607,61610, 61614 |
| CHEMICAL NAME |
|
CAS NUMBER |
| N/A |
|
N/A |
HAZARDOUS INGREDIENTS
| COMMON NAME | CHEMICAL NAME | CAS NO. | OSHA PEL | ACGIH TLV-TWA |
| Petroleum Hydrocarbon |
Petroleum Distillate |
68476-34-6 |
Not Established |
Not Established |
| Petroleum Hydrocarbon |
Petroleum Distillate |
64741-97-5 |
Not Established |
Not Established |
Contains no other ingredients now known to be hazardous as defined by OSHA 29CFR 1910.1000(z) and 29CFR 1910.1200.
PHYSICAL DATA
These data are approximate or typical values and should not be used as precise specifications. Unless otherwise noted values are at 20°C(68°F) and 760 mmHg (1 atm)
| Boiling Point/Range |
325-700700F (162.8-371°C) |
Freeze Point |
-2525°F(-31.6725°C) |
| Specific Gravity (H20=1) @ 15.625C |
0.86 |
Vapor Pressure (mm Hg) |
N/D |
| Vapor Density (Air =1) |
Heavier Than Air |
Solubility in Water (%) |
Disperses |
| % Volatiles by Volume |
Negligible |
Evaporation Rate (Butyl Acetate = 1) |
N/D |
| pH (as is) |
N/D |
pH (dilute) @ % |
N/A |
| Appearance |
Clear Brown Thin Liquid |
Odor |
Hydrocarbon |
N/D - Not Determined
< = Less Than
N/A - Not Applicable
> = Greater Than
FIRE AND EXPLOSION HAZARD DATA
Flash Point: 47525°F(24625°C) Method Cleveland Open Cup ASTM D-92
Flammable or Explosive Limits (Approximate percent by volume in air)
Lower (LEL) N/D Upper (UEL) N/D
Hazard Class Identification
Flammability 2
Health 2
Reactivity 0
Other -
Hazard Code
0 - Least (insignificant)
1 - Slight
2 - Moderate
3 - High
4 - Extreme
Extinguishing Media
Dry chemicals, carbon dioxide, water spray, foam.
Special Fire Fighting Procedures
Use water only to cool fire exposed containers. Fire fighters wear a self contained breathing apparatus.
Unusual Fire and Explosion Hazards
The material is combustible and may be ignited by heat or flame.
REACTIVITY DATA
Stability
Stable.
Conditions to Avoid
Heat, open flame.
Materials to Avoid
Strong oxidizing agents.
Hazardous Decomposition or Combustion Products
Thermal decomposition may produce oxides of carbon, nitrogen, phosphorus, and zinc.
Hazardous Polymerization Will not occur.
HEALTH HAZARDS/ROUTES OF ENTRY
Signs, Symptoms and Effects of Overexposure
Ingestion (swallowing)May be harmful or fatal if swallowed. Due to its low viscosity, it may enter lungs during swallowing or vomiting. Once in lungs serious damage may occur.
Skin Contact Can be absorbed through skin on prolonged contact. Single contact, no effect likely. Prolonged and repeated contact can result in defatting and drying of the skin. Can cause redness and itching.
Eye Contact May cause irritation, burning, blurred vision and redness.
Inhalation (breathing) Inhalation can cause irritation to nose and throat and upper respiratory tract. Concentrated vapor respiration can cause dizziness, nausea and central nervous system damage.
Other Effects of Prolonged/Repeated Overexposure
This material has not been identified as a carcinogen by NTP, IARC or OSHA. Kidney damage may occur if large quantities are swallowed.
EMERGENCY AND FIRST AID PROCEDURES
Ingestion (swallowing) DO NOT induce vomiting. Call for medical help.
Skin Contact Wash affected area with soap and water. Remove contaminated clothing.
Eye Contact Flush with water for 15 minutes. If irritation persists call for medical help.
Inhalation (breathing) Remove person to fresh air to avoid further inhalation.
Comments NOTE TO PHYSICIANS: Treatment should be based on symptoms and clinical condition.
SPILL OR RELEASE CONTROL PROCEDURES
Steps to be taken in case material is released or spilled
Ventilate area. Avoid breathing of vapors. Remove with inert absorbent.
Waste Disposal Method
Dispose of in accordance with Federal, State and Local regulations.
ENVIRONMENTAL HAZARD (EPA-CWA, SECTION 311)
Spills of this material leading to surface waters where it will cause a sheen must be reported to the National Response Center (800) 424-8802.
EPA Reportable Quantity (RQ), 40CFR302 (CERCLA104)
N/A
EPA Toxic Chemical Release Reporting, 40CFR372(SARA313)
| Chemical | CAS NO. | % in Product |
| Zinc Compound | - | 1.75 |
HANDLING AND STORAGE
Handling and Storage Precautions
WARNING: Contains petroleum distillates. Avoid skin and eye contact. Avoid breathing of vapors. Combustible. Keep away from heat and sparks. Use entire contents. DO NOT store opened containers.
Other Precautions
KEEP AWAY FROM CHILDREN.
PERSONAL PROTECTION - EXPOSURE CONTROL
Ventilation
Provide adequate general or local ventilation to maintain concentrations below TLV/PEL limits.
Respiratory Protection
None normally required. If vapors exceed TLV/PEL values, use a NIOSH approved respirator
Eye Protection
Safety glasses with side-shields.
Protective Gloves
Chemical-resistant gloves.
Other Protective Clothing or Equipment
Eye wash station is recommended.
Work/Hygienic Practices
Personal cleanliness is always appropriate. Frequent washing minimizes chances of inadvertent exposure.
TRANSPORTATION INFORMATION
Department of Transportation (DOT) Classification
| |
Flammable Liquid |
|
Corrosive |
| |
Flammable Solid |
|
Non Flammable Gas |
| |
Flammable Gas |
|
Non Hazardous by DOT |
| |
Combustible Liquid |
|
Other |
DOT Proper Shipping Name
N/A
DOT ID Number
N/A
DOCUMENTATION
Product Code No.: 61603, 61607, 61610, 61614
Previous Code No.: 61603, 61607, 61609, 61610, 61611, 61614, 61616, 61629, 61630
Issue Date: 08-30-05
Prior Date: 06-18-04
This information is, to the best of our knowledge and belief, accurate and reliable as of the date compiled. However, no representation, warranty or guarantee is made as to its accuracy, reliability or completeness. It is the user's responsibility to satisfy himself as to the suitability and completeness of such information for his own particular use.
|
Wynn’s Oil System Cleaner & Conditioner safely dissolves and suspends engine oil deposits throughout the engine. from the valves to the oil pan. Optimum lubrication is provided for with this non-solvent based formula that includes extreme pressure lubrication agents. These agents are metal conditioners that provide additional anti wear protection from metal-to-metal contact during the cleaning operation